All seven services are available across the township. This is how each one tends to show up in Verona's mix of older and postwar houses.
Sweeping fireplaces and furnace flues
A Verona house with a working fireplace should have that flue swept whenever buildup is found, which for a regular wood burner is usually once a year. We also brush the furnace or boiler flue when it shares the chimney, pull out nests and leaves, and leave the hearth as clean as we found it.
Chimney sweeping in Bloomfield and nearby →Crowns, caps and dampers
The crown is the concrete slab that caps the brick, and on older Verona chimneys it is often the original, thin and cracked across. We seal small cracks, recast a failing crown, fit a new cap with a screen, and repair or replace dampers that no longer close tight. A screened cap also keeps out the leaves, twigs and small animals that would otherwise drop into an open Verona flue.
Chimney Repair →New liners for old flues
Many Verona chimneys were built around clay tile flues, and the oldest may have no liner at all. When a camera shows cracked or missing tiles, or a new heating unit needs a smaller flue, we install a stainless steel liner matched to the furnace, boiler or fireplace on that flue, then cap it. A properly sized liner also helps the flue draw well.
Chimney Liner Replacement →Repointing and brick replacement
Mortar on a Verona chimney that has stood through many decades of freezing winters tends to go sandy and fall out of the joints. We grind out the loose mortar, repoint with a mix suited to the brick, and swap out bricks whose faces have spalled off. Catching it early keeps the repair to a few courses instead of the whole stack.
Chimney Masonry Repair →Flashing where roof meets brick
When a Verona roof is replaced, the chimney flashing is not always redone properly with it. Old metal tucked under new shingles is a common leak source. We install new step and counter flashing cut into the mortar joints, and a cricket behind a wide chimney. A cricket is a small peaked ridge that sheds water around the brick instead of letting it pool.
Chimney Flashing Repair →Camera inspections before a sale
A Verona chimney can look fine from the yard and still hide cracked tiles inside. A Level 2 inspection uses a camera to see the full length of every flue, plus the accessible attic and basement areas, and you get photos and a written summary. It is also the right check after a chimney fire or a change of heating system.
Level 2 Chimney Inspection →Rebuilding the stack above the roof
When frost has loosened brick near the top of a Verona chimney to the point where it moves by hand, repointing will not hold. We take the stack down to solid masonry, rebuild it with matching brick, and finish with a new crown and flashing. Ask the township about a permit before the work is booked.
Chimney Rebuild →