Every service is available anywhere in the city. This is how each one usually comes up in Clifton homes.
Sweeping and blockage removal
In Clifton we sweep fireplace flues, clear out old nests and leaves, and brush furnace and boiler flues that have collected soot or fallen debris. A blocked flue can send exhaust back into the house, so we check that every flue in use is clear from the firebox or connector to the top of the chimney.
Chimney sweeping in Bloomfield and nearby →Caps, crowns and dampers
A screened cap is the single best defense against animals and debris in a Clifton chimney. We install stainless caps sized to the flue or to the whole crown, repair cracked crowns, and fix or replace dampers that have rusted open, so the chimney stays dry and closed off when not in use. A cap is a small part with a big effect.
Chimney Repair →Liners sized for each appliance
Most Clifton homes heat with gas, and a modern gas furnace often needs a smaller flue than the original clay one. In a two-family house there may be two appliances to consider. We install stainless liners sized for each unit, which keeps condensation from attacking the tiles and mortar. Each liner is capped at the top.
Chimney Liner Replacement →Repointing older brick
With so much of Clifton's housing built before the middle of the last century, worn mortar is worth checking for on any older chimney in the city. We repoint open joints, replace cracked or flaking bricks, and choose a mortar that suits the age and hardness of the existing brick. Hard modern mortar can crack soft old brick around it.
Chimney Masonry Repair →Flashing and roof-line leaks
A stain on a Clifton ceiling next to the chimney usually traces back to the flashing. We remove failed metal and caulk patches, install step flashing woven into the shingles and counter flashing set into the mortar, and add a cricket where a wide chimney blocks the flow of water. Caulk alone does not last on a roof.
Chimney Flashing Repair →Video inspection of every flue
Buying a Clifton home, changing a heating unit or recovering from a chimney fire are the usual reasons for a Level 2 inspection. A camera shows the inside of each flue, cracks and gaps included, and the report gives photos you can share with a buyer, seller or insurer. It covers attic and basement areas we can reach as well.
Level 2 Chimney Inspection →Rebuilding a failing chimney
If the bricks at the top of a Clifton chimney are loose, leaning or falling onto the roof, the safe answer is to rebuild from solid masonry. We relay the stack with brick chosen to match, add a new crown and flashing, and check permit needs with the city first. A partial rebuild is often enough when the lower brick is sound.
Chimney Rebuild →